Free trial
XTMeasure 27 demo
Video measuring software for toolmaker's microscopes. Pick points, lines, circles and arcs on a picture to measure distances, angles, diameters and radii, build constructions and geometric tolerances, and make Excel and PDF reports. Try it without a camera or stage, on the sample pictures or on your own image files.
Demo terms
- Runs without a hardware key (dongle).
- The camera, real stages and the XTTile/XTFocus link work in the full version. The trial supports the sample pictures, your own pictures and the stage emulator.
- Up to 3 hours (180 min) of cumulative run time; closing and reopening continues the count.
- Ends 14 days after the first launch even if time remains.
- Saved pictures and reports carry a DEMO mark. Measured values are unaffected.
- After it ends, the screen and saved results stay viewable; only measuring is blocked.
What you can do
- Try distance, angle, diameter, radius, concentricity and parallelism on the four sample pictures (a part, a flange, a 60-degree notch with a corner radius, a stepped pin)
- Open your own picture files (PNG, JPG, BMP, TIF), calibrate and measure
- Constructions, alignment, geometric tolerances, program record and run
- Measure while moving with the stage emulator
- Result tables, statistics, annotations, reports (Excel, PDF)
Requirements
- Recommended OS: Windows 10 64-bit (64-bit only)
- .NET Framework 4.8 (installed during setup if missing)
- No camera or stage needed
Need the full version?
The full version is used with a dedicated hardware key (dongle). Purchases and quotes are handled by inquiry.